Bulldog Security 1402 Installation And Owner's Manual - page 13
HOW TO USE YOUR REMOTE TRANSMITTER
12
2
3.5 sec. Door Lock Pulse Length
2
1
Negative Input Activated
2
Negative Input Deactivated
3
1
Siren Tone Output
2
Car Horn Output
4
1
Positive Door Pin Input
2
Negative Door Pin Input
TABLE FIVE
BUTTON FLASHES
SETTING
2
1
Delayed Dome Lights Activated
2
Delayed Dome Lights Deactivated
TO EXIT PROGRAMMING MODE
Turn the ignition switch to the off position. The parking lights will flash 3 times.
LED STATUS INDICATOR
The LED (Red Light) provides valuable information about the 1402 and is also used as a theft deterrent
to would-be thieves.
STATUS
LED DISPLAY
Armed
Flashing Slow
Disarmed
Off
Passive Arming
Flashing Fast (Arming Count Down)
Valet
Constantly On
VIOLATED ZONE
TRIGGERED DEVICE
NUMBER OF FLASHES
Zone 3
External Sensors
3 Flashes
Zone 4
Door Switches
4 Flashes
1
3
2
4
BULLDOG
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
KEYLESS ENTRY FUNCTIONS
LOCKING DOORS
Press transmitter button #1 to lock the doors. The
parking lights will flash once and the horn or siren
will sound acknowledging the unit received the
signal.
UNLOCKING DOORS
Pressing transmitter button #1 again will unlock
the doors. The parking lights will flash twice and
then stay on for approximately 30 seconds and the
horn or siren will sound twice acknowledging the
unit received the signal. NOTE: If dome light feature
is installed, the dome light will come on and stay
on for 30 seconds.
LOCKING AND UNLOCKING WITH IGNITION SWITCH
See keyless entry programming options. NOTE: If your vehicle already has this option, (Factory
Installed) do not activate.
FULL TIME SILENT KEYLESS ENTRY
This will eliminate the horn or siren from sounding when locking or unlocking your doors (See Silent
Arming & Disarming in Alarm Programming Options).
ALARM FUNCTIONS
VALET MODE
The valet mode prevents the system from arming while in passive or active arming. To activate valet
mode, first disarm the system. Hold down button #4 for 10 seconds. The system will chirp once and
the parking lights will flash once. The LED will remain solid red when in valet mode. To deactivate
valet mode, repeat the above; however, the system will now chirp twice and the LED turns off.