Bulldog Security DELUXE 500 Installation Manual - Wiring Connections
. .
18
WIRING CONNECTIONS
H7/4 BLACK/WHITE (Dome Light Supervision Output)
The BLACK/WHITE wire provides a 200mA (-) negative output for 30
seconds when the doors are unlocked using the transmitter. The
BLACK/WHITE wire will also flash the dome light circuit for the same
duration as the siren when violated. Note: If not attaching the
BLACK/WHITE wire directly to the BCM (Body control module) a
relay must be used to power the dome light circuit.
H7/5 BLACK/RED (Timer Control Channel 5 Programmable Output)
The BLACK/RED wire provides a 200mA (-) negative programmable
ground output for a variety of optional devices. The output on the
BLACK/RED wire is programmable from 1 to 120 seconds. (See Alarm
Feature #3 Programming Chart)
This wire can be used to open a sunroof, or any power device you choose
to control. The BLACK/RED wire must be wired to a relay when powering
any devices. Note: factory default setting is a 1 second momentary
ground. (See Alarm Feature #3 Programming Chart)
To activate this feature press the transmitter and buttons at the
same time.
H7/6 VIOLET/BLACK (Timer Control Channel 4 / Key Sensor Output)
The VIOLET/BLACK wire provides a 200mA (-) negative programmable
ground output for a variety of optional devices. The output on the
black/violet wire is programmable from 1 to 120 seconds. (See Alarm
Feature #3 Programming Chart)
This wire can be used to open a sunroof, or any power device you choose
to control. The VIOLET/BLACK wire must be wired to a relay when
powering any devices.
Note: factory default setting is a 1 second momentary ground.
(See Alarm Feature #3 Programming Chart)
Note: this wire can also be programmed as a second start crank
output. . (See Alarm Feature #3 Programming Chart)
Some vehicles require a second starter wire to be energized, or on certain
GM vehicles what is known as the bulb check wire must receive a ground
signal while the starter is cranking. When using this wire as a second
start wire (Most Nissan vehicles) a relay must be used to energize this
circuit. Press the transmitter and buttons at the same time.