Bulldog Security DELUXE 500 Installation Manual - Programming
. .
29
PROGRAMMING
6 +
3 Hour Time
2 Hour Time
Start
Start
7 +
The Vehicle
The Vehicle has
Built-in Turbo
Built-in Turbo
without Turbo aftermarket Turbo Timer Control is Timer Control is
(The system
timer installed.
Active. Press
Active: Press
cannot be
The system
+ buttons at
+ buttons at
Arm with the
can be Arm with the same time
the same time to
engine is
engine running
to control
control Engine
running.
and the shock
engine running
running three
sensor will be by- one minute.
minutes.
pass as long as
the engine is
running.
Five chirps=Built-in Turbo Timer Control is Active/Press
and buttons at the same time to control Engine
runningfive minutes.
START FEATURE CHART #2
One Chirp with
Press
One LED Pulse
Transmitter Factory Default Two Chirps with
Three Chirps with Four Chirps with
Button
Setting
Two LED Pulses
Three LED Pulses Four LED Pulses
1
Exit the programming mode. (3 long chirps and 3 parking light flashes
to confirm this exit.)
2 +
Engine Checking Engine Checking Engine Checking Engine Checking
Voltage
TACH / RPM
Negative Oil
Positive Oil
Learning Mode
Sensor
Sensor
3
Start Timer:
0.8-second (2 chirps), 1.0-second (3 chirps) 1.2-second
0.6-second
(4 chirps), 1.4-second (5 chirps), 1.6-second (6 chirps),
1.8-second (7 chirps), 2.0-second (8 chirps), 3.0-
second (9 chirps), 4.0-second (10 chirps.
4
Low check level Hi check level
5 +
Start or stop the system for TESTING AND ADJUSTMENT