Bulldog Security DELUXE 500 Installation Manual - Programming
. .
34
PROGRAMMING
To Exit: Turn Ignition to the on position, or leave it for 15 seconds. 3
long chirps and 3 parking light flashes will confirm programming exit.
SHUTDOWN DIAGNOSTICS
The unit has the ability to diagnose and report the cause of the last
shutdown on the remote start system.
Enter:
1. Turn the Ignition switch to the ON position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns.
LED
Flashes Shutdown Mode
1
(-) Safety Shutdown
1.Close the Hood
Input (Hood)
2.Check H5/1 GREY wire connection
2
(+) Safety Shutdown Input 1.Set the Hand Brake (if installed)
(Brake) or Hand Brake (if
2.Check H5/2 BROWN/RED wire
installed or
connection.
Neutral Safety Switch
3.Move the Enable Toggle Switch to
input fail
ON position. (if installed)
4.Move the gear selector to Park/
Neutral position.
5.Check H5/3 THIN BLACK wire
connection.
3
No RPM (Engine Checking
Check H5/9 VIOLET/WHITE wire
TACH) or
connection.
Low Voltage. (Engine
Program the CHECK LEVEL from
Checking Voltage) or
Hi Check Level to Low Check Level
Oil Sensor (Engine
Check H5/9 VIOLET/WHITE wire
Checking Oil Sensor)
connection.
4
Over-rev
5
System timed out
6
Transmitter