Bulldog Security DELUXE 500 Installation Manual - Important Notice

.                                                           .

6

IMPORTANT NOTICE

COMPONENTS

• 1- Main Control Module

• 1- Five Button LCD Remote

Transmitter

• 1- 6 Pin Ignition Harness

• 1- 5 Pin Harness

• 1- 10 Pin Mini Output Harness

• 1- 9 Pin Mini Input Harness

• 1- 2 Pin Valet Switch

• 1- 2 Pin Led Light Harness

• 1- 4 Pin Antenna Harness

• 1- 6 Pin Door Lock Harness

• 1- Hood Switch

• 1- Hood and Window Decal

• 1- Installation Manual

• 1- Owners Manual

• Read the operation manual for operating and programming routine.

• Do not install any component near the brake, gas pedal or steering

linkage.

• Most vehicles have an SRS air bag system. Use extreme care and

do not probe any wires of the SRS system. These wires will almost

always be located inside a bright yellow tube located near the

steering wheel column.

• Check behind panels before drilling any holes. Ensure that no wiring

harness or other components are located behind the panels that

would otherwise be damaged.

• Do not use conventional crimp lock or bullet connectors on any

wiring.

• Do not disconnect the battery if the vehicle has an anti-theft radio

or is equipped with an airbag. Doing so may cause a warning light

to be displayed and the radio to stop functioning.

• Do not leave the interior or exterior lights on for an extended

period of time. Remove the dome light fuse from the vehicles fuse

box.

• Do not mount the control module until all connections have been

made and the unit is programmed and tested.

• Finally place the warning sticker under the hood when the installation

is completed.