Bulldog Security DELUXE 500 Installation Manual - Programming
. .
33
PROGRAMMING
2. If the crank time is too long, (Engine already successfully running, while
the starter is still cranking):
a. Press the button twice on the transmitter to stop engine from
running.
b. Press the button on the transmitter to set proper the Start Timer.
The chirp and LED pauses will confirm you are in the start timer mode.
(Decreasing the Start Time is necessary.)
c. Repeat the step1 4.
3. If the crank time is too short (The engine is not running and the starter
did not engage long enough)
a. Press the button twice on the transmitter to turn off the ignition.
b. Press button on the transmitter to set proper Start Timer. The
chirps and LED pauses will confirm you are in the start timer mode.
(Increasing the start timer is necessary.)
c. Repeat the step1 4.
RETURN TO FACTORY DEFAULT SETTING:
Note: This will reset all alarm features to factory default settings
1. Turn the ignition from ON to OFF (3) times and stay in the
OFF position.
2. Push the valet switch (12) times and hold it until (6) short chirps
followed by a long chirp is heard.
Press and hold the and buttons at the same time on the transmitter
for 6 seconds, there will be a confirmation of (6)short chirps with (3)
long chirps to confirm the system Alarm Features #1, #2 and #3
programming all return to factory default settings.
Note: This will reset all remote starter features to factory default
settings
1 Press the button first, within 3 seconds press and hold the and
buttons at the same time on the transmitter for 6 seconds, there will
be a confirmation of (6) short chirps followed by 3 long chirps to
confirm the system Start Feature #1 and #2 programming will
return to factory default settings.