Bulldog Security DELUXE 500 Installation Manual - Table of Contents

.                                                           .

TABLE OF CONTENTS

5

This remote starter with keyless entry system is designed to be

installed on fuel injected vehicles only.

• This system must be installed and wired through a safety switch 

to assure that it will not start in any forward or reverse gear.

• Some automatic transmission vehicles [mainly older GM models 

with a purple starter wire] have a mechanical-type park mechanism

instead of an electrical safety switch. The mechanical type does 

not interrupt the starter circuit when the transmission is any gear

and does not offer the 100% level of safety required for remote 

starting purposes. Therefore, you must create a circuit that will 

prevent the remote starter from engaging when the key is in the

ignition.

• Once you install this system, you must verify that the vehicle will

not start any forward or reverse gear.

IMPORTANT NOTICE

   Start Feature #1 Programming ................................................27-28

Safe Start (Child Safety Mode)

       Temperature Start Programming

Start Feature #2 Programming ................................................28-29

       Engine Checking TACH. – RPM Learning & Testing .......................30

       Engine Checking Voltage – Start Timer Set-up & Testing ..............31

       Engine Checking Oil Sensor – Start Timer Set-up & Testing ..........32

       Turbo Mode

       Range Check

RETURN TO FACTORY DEFAULT SETTING ....................................33

SHUTDOWN DIAGNOSTICS.....................................................34-35

TESTING YOUR INSTALLATION ..............................................35-39

   Test the Brake shutdown circuit

   Test the Hood Pin shutdown circuit

   Neutral Start Safety Test

   Mechanical Neutral Safety Switch Considerations

   Park/Neutral ECM Input

   Key In Sensor Circuits