Bulldog Security DELUXE 500 Installation Manual - Programming
. .
28
PROGRAMMING
Exit: Turn Ignition to ON position, or leave it for 15 seconds. 3 long
chirps and 3 parking light flashes to confirm exit.
SAFE START (Child safety mode)
Factory defaults setting to press the button twice to start the vehicle.
Programming this feature to eliminate an accidental remote start, when
kids enter this transmitter, it requires: The user press the transmitter and
buttons at the same time to start the vehicle.
START FEATURE. # 2 PRORAMMING:
1. Turn the ignition switch from OFF to ON 3 times and stay in the
OFF position.
2. Push the valet/program switch 10 times and hold it in on the 10
th
push until (5) chirps followed with (1) long chirp is heard and the
then release the valet/program switch. You are now in the start
feature #2 programming mode.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.
One Chirp with
Press
One LED Pulse
Transmitter Factory Default Two Chirps with
Three Chirps with Four Chirps with
Button
Setting
Two LED Pulses
Three LED Pulses Four LED Pulses
6 +
Press - Press +
Press button =
Button=Activate Button=Activate Activate Remote
Remote Start
Remote Start
Start
7 +
Fahrenheit
Celsius Display
Display for
for Temperature
Temperature
8 + Temperature-
Temperature-
Temperature-
Temperature-
Control I Start- Control Starting Control Starting Control Starting
ing OFF
5F (-15C)
- 4F (-20C)
- 22F (-30C)