CAME ZM3E Installation Manual - page 15
p.
1
5
15
-
M
an
u
al c
od
e:
F
A
0
0
3
8
5
-E
N
FA
0
0
3
8
5
-E
N
v.
11
02
/2
0
1
6
© C
A
M
E c
an
ce
lli auto
m
ati
ci S
.p.
A
. -
Th
e c
onte
nts of th
is m
an
u
al m
ay b
e c
h
an
g
ed at a
ny ti
m
e w
ith
ou
t p
rio
r n
oti
ce
.
Users Menu
[USERS]
[Add User]
Entering up to 250 users and associating to each one a function of choice among those included. Enter by using a transmitter or other
control device (see the ENTERING A NEW USER paragraph).
[Change Name]
For
changing the user number or name
[Change Code]
To modify the command code that is associated to a user
.
[Assoc Function]
2-7
Open
2-3P
B1-B2
➡
Step-step command (open-close) or sequential command (open-stop-close-stop)
➡
Open only command
➡
Pedestrian or partial opening
➡
Contact B1-B2 output
[Delete user]
To remove a user. Confirm removal with ENTER.
[Delete ALL]
To remove all users. Confirm removal with ENTER.
[SENSOR]
[Keypad] / [Transponder]
To set the type of sensor for controlling the operator.
[Save memory]
To save system users and settings in memory roll. Confirm saving with ENTER.
[Load memory]
For uploading the data saved in the memory roll onto the electronic board.
If the boards feature different versions, you may only upload the users.
Info menu
Motors Test menu
[
<= M1 M2=>
]
For checking the proper rotation direction of the gearmotors.
Keep the < key pressed for some seconds and check that M1's leaf has opened. If the rotation direction is wrong, invert the motor's phases.
Keep the > key pressed for some seconds and check that M2's leaf has opened
. If the rotation direction is wrong, invert the motor's phases.
[MOTORS TEST]
[INFO]
[Version]
View software version.
[No. of travels]
View the number of completed maneuvers.
[Start message]
View opening message. To edit the text, press ENTER. Use ENTER to move the cursor forward, ESC for moving the cursor backward and <
> to select the letter of figure. Confirm text by pressing the ENTER key for some seconds.
[Reset system]
To restore the initial settings. Press ENTER to confirm the Reset.
www.metalines.com
sales@metalines.com