CAME ZM3E Installation Manual - page 19
0
0
D
B
A
B
D
B
B
D
A
D
E
F H
G
M
N
O
O
O
C
C
I
L
p.
1
9
19
-
M
an
u
al c
od
e:
F
A
0
0
3
8
5
-E
N
FA
0
0
3
8
5
-E
N
v.
11
02
/2
0
1
6
© C
A
M
E c
an
ce
lli auto
m
ati
ci S
.p.
A
. -
Th
e c
onte
nts of th
is m
an
u
al m
ay b
e c
h
an
g
ed at a
ny ti
m
e w
ith
ou
t p
rio
r n
oti
ce
.
DIAGRAM OF THE SLOW-DOWN AND FINAL APPROACH POINTS AND FOR THE ENCODER DEVICE
The run area and slow down and approach points are tested according to the parameters set forth by Technical Standards EN 12455 and
EN 12453 for compliance with the impact forces generated by the running leaves.
A = Normal speed
B* = Slowed-down speed
C = Encoder intervention zone with movement inversion
D = Encoder intervention zone with movement stopped
E = Opening slow-down starting point [M1 Opn Slw Dwn]
F = Closing slow-down starting point [M1 Cls Slw Dwn]
G = Opening slow-down starting point [M2 Opn Slw Dwn]
H = Closing slow-down starting point [M2 Cls Slw Dwn]
I** = Closing approach starting point [M1 Close Accel]
L** = Closing approach starting point [M2 Close Accel]
M** = Opening deceleration point [M1 Open Accel]
N** = Opening slow-down starting point [M2 Open Accel]
O = Strike plates
* Minimum 600 mm from the strike plate.
** Set the fi nal approach percentage for the function [M1 Close Accel] for M1 and [M2 Close Accel] for M2 from the [ENCODER] menu so
as to obtain a distance of between 1 and 50 mm maximum from the fi nal strike plate point.
DISMANTLING AND DISPOSAL
Always make sure you comply with local laws before dismantling and disposing of the product. The packaging materials (cardboard, plastic, and
so on) should be disposed of as solid urban waste, and simply separated from other waste for recycling.
Whereas other components (control boards, batteries, transmitters, and so on) may contain hazardous pollutants. These must therefore be
disposed of by authorized, certified professional services.
DO NOT DISPOSE OF IN NATURE!
DECLARATION OF CONFORMITY
Declaration
- Came S.p.A. declares that this device conforms to the essential, pertinent requirements provided by directives 2004/108/EC
and 2006/42/CE.
An original copy of the declaration of conformity is available on request.
www.metalines.com
sales@metalines.com