CAME ZM3E Installation Manual - page 3
4
3
2
1
1
2
3
5
4
7
8
9
10
15
14
11
12
13
16
27
26
25
24
6
23
21
22
22
20
19
18 17
CAME
31
30
29
28
p.
33
-
M
an
u
al c
od
e:
F
A
0
0
3
8
5
-E
N
FA
0
0
3
8
5
-E
N
v.
11
02
/2
0
1
6
© C
A
M
E c
an
ce
lli auto
m
ati
ci S
.p.
A
. -
Th
e c
onte
nts of th
is m
an
u
al m
ay b
e c
h
an
g
ed at a
ny ti
m
e w
ith
ou
t p
rio
r n
oti
ce
.
ZM3EC
Description of parts
1. Transformer
2. M1 gearmotor condenser (black cables)
3. M2 gearmotor condenser (red cables)
4. Control board fuse
5. Accessories
fuse
6. Terminals for the GP1 module
7. Electrolock
fuse
8. Display
9. Display brightness adjusting trimmer
10. Memory roll board connector
11. Programming buttons
12. Power supply on warning LED
13. Programming warning LED
14. Connector for the R700 / R800 card
15. AF card connector
16. Keypad selector terminal
17. Antenna terminal
18. Terminals for second channel output
19. Endstop terminals
20. Terminals for transponder devices
21. Terminals for control and safety devices
22. Encoder terminals
23. Terminal board for microswitches
24. CRP connection terminals
25. RSE board connector
26. Power supply terminals
27. Line fuse
28. STOP button
29. CLOSING button
30. OPENING button
31. Safety lock
GENERAL INSTRUCTIONS FOR INSTALLING
⚠
Only skilled, qualified staff must install this product.
⚠
Before working on the control panel, cut off the main current supply and, if present, remove any batteries.
Preliminary checks
⚠
Before installing the control panel it is necessary to:
• make sure that the point where the control panel is fastened is protected from any impacts and that the anchoring surface is solid enough,
and that proper tools are used (that is, screws, anchors, and so on);
• make sure you have set up a suitable dual pole cut off device along the power supply that is compliant with the installation rules. It should
completely cut off the power supply according to category III surcharge conditions (that is, with minimum contact openings of 3 mm);
• Make sure that any connections inside the container (ones that ensure continuity to the protection circuit) are fitted with additional insulation
with respect to those of other electrical parts inside.
www.metalines.com
sales@metalines.com