Campbell CCFC Instruction Manual - page 64
CCFC Field Camera
54
Table 12-18 Access Point Settings
Variable
Toggle, Drop Down,
Numerical, or Text
Description
AP Name*
Text
A user friendly name that will show up when searching for
networks.
AP Channel*
Drop down
Select from 1 – 11.
Wi-Fi channel to be used for the AP. Can be changed to
reduce interference from other nearby Wi-Fi networks.
IP Address*
Number (e.g.
10.0.01)
Camera IP address when acting as an access point.
Netmask*
Number (e.g.
255.0.0.0)
Network mask of the Wi-Fi network to be used.
DHCP Start
Number (e.g.
10.0.010)
Start of the address range to give to connecting clients.
DHCP End
Number (e.g.
10.0.0.19)
End of the address range to give to connecting clients.
AP Security
None
WEP
WPA – Personal
WPA2 - Personal
The type of encryption uses to secure the network. It is
STRONGLY recommended to enable encryption to
increase the security of the camera.
AP Password
Text
Used when AP Security is activated. This password will be
used when connecting to the camera via Wi-Fi (see Section
11.1 Setup Using Wi-Fi).
*Required.
12.8.2.3.2 Existing Network
The Wi-Fi settings information appears when the camera Wi-Fi is configured
to operate with an existing network. Typically, this mode would be used when
the camera is regularily connected to an existing Wi-Fi network to transfer files
or to eliminate the need to connect a wired Ethernet cable.
Figure 12-31 Connect to Existing Network