Campbell CCFC Instruction Manual - 13. Rs-232 Communications
CCFC Field Camera
74
Figure 12-52 History
13. RS-232 Communications
The RS-232 serial communications are used with the camera for two purposes:
to configure and setup the camera using Device Configuration Utility software
that Campbell Scientific provides and to send photo files from the camera to
other devices using the PakBus protocol.
This value is displayed on the web interface under Settings>File
Transfer>PakBus.
Figure 13-1 PakBus Settings
The CCFC Power I/O port is configured by default to provide a 3-wire RS-232
connection (Tx, Rx, Ground), as well as power. The wires can be terminated
directly on the control ports of a compatible datalogger. For connection to a
computer’s 9 pin serial port, use the L28840 DB9 FEMALE to Terminal Block
Adaptor, which facilitates the connection of the cable pigtail end to a computer
9-pin serial port. The adaptor is included with the CCFC.