Canon ImageCLASS MF4690 Service Manual - page 103
Chapter 9
9-5
F-9-20
2) Unhook the claw [1], and remove the cable guide [2] in the direction of
the arrow.
F-9-21
3) Remove the 4 screws [1], and detach the scanner cover (front) [2] and the
scanner cover (rear) [3].
F-9-22
Points to Note When Attaching
Make sure to insert the shutter arm [4] through the hole [5] of the scanner
cover (rear).
4) Disconnect the 2 connectors [1] located at the left side, and put them in-
side the left side plate through the holes [2].
F-9-23
5) Disconnect the 6 connectors [1], and free the cable [2] through the hole of
PCB.
6) Free the cable [3] from the cable clamp [4].
F-9-24
7) Disconnect the connector [1] to remove the flat cable [2].
F-9-25
Points to Note When Attaching
Make sure to put the flat cable [3] through the hole [4].
8) Remove the 2 screws [1].
F-9-26
9) Disconnect the connector [1], put the cable [2] through the cable clamp
[3], and remove the DCNT board [4].
F-9-27