Canon ImageCLASS MF4690 Service Manual - page 150
Chapter 14
14-10
14.3.7 SSSW-SW13
14.3.7.1 List of Functions
0016-2017
T-14-9
14.3.7.2 Detailed Discussions of Bit 2
0016-2018
It converts "inch" into "mm" when transmitting the received image data.
Scanning direction in conversion follows the Bit 2 setting of SW14.
14.3.8 SSSW-SW14
14.3.8.1 List of Functions
0016-2019
T-14-10
14.3.8.2 Detailed Discussions of Bit 2
0016-2020
Use it to specify whether to convert or not convert an inch-configuration resolution into a millimeter-configuration resolution for image read in G3 transmission:
either in sub scanning direction only or in both main and sub scanning directions. The setting is valid only when bit 1 of SW05 of #SSSW is set to '1'.
14.3.8.3 Detailed Discussions of Bit 4
0016-2021
Use it to specify whether to declare or not declare an inch-configuration resolution to the other machine for G3 communication: if 'declare' is selected, the machine
will indicate that it reads and records at an inch-configuration resolution using the DIS, DCS, or DTC signal.
14.3.9 SSSW-SW18
14.3.9.1 List of Functions
0016-2022
T-14-11
32 min
1
*
1
0
*
*
*
*
64 min
1
*
1
1
*
*
*
*
Bit
Function
1
0
0
not used
-
-
1
not used
-
-
2
Convert "inch" into "mm" when transmitting the received
image data
convert
do not convert
3
not used
-
-
4
not used
-
-
5
not used
-
-
6
not used
-
-
7
not used
-
-
Bit
Function
1
0
0
not used
-
-
1
not used
-
-
2
direction of scanning for inch/mm conversion
both main and sub
scanning directions
sub scanning
direction only
3
not used
-
-
4
inch-configuration resolution declaration
declare
do not declare
5
not used
-
-
6
not used
-
-
7
not used
-
-
Bit
Function
1
0
0
Detection of carrier disconnection between the DCS
signal and the TCF signal
Yes
No*
Time-Out Length for
Reception
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0