Concept Pro VXH960-16 User Manual - page 11
8
Connecting to an external device
Installation
This product supports 1080p 60 Hz HDMI monitors and regular monitors that support VGA inputs.
Connect a HDMI cable to the port on the rear of the VXH960 or use a VGA cable to connect the
DVR with a VGA monitor
Once the product is set to NTSC or PAL connect cameras of the corresponding
videostandard for proper operations.
Setting the product to NTSC or PAL decides available display output modes too.
R
The monitor’s displaying operates at 50Hz if the product has been set
to PAL output and the connected monitor supports both 50Hz and
60 Hz inputs.
For NTSC setting, it works at 60 Hz.
!
Make sure to connect the product to a monitor that supports 1920x1080
at 60Hz.
Power Connection
Apply power to DVR main unit, and connect the provided DC 48V power supply adaptor to the external
PoE switch (Power over ethernet).
Plug the power cable into the unit whilst the power is off at the wall.
Arrange up the cables and be careful not to peel off the cable coating.
Do not place the power cord under the carpet or rug. The power cord is usually
earth-grounded. However, even if it’s not earth-grounded, do not modify it for earth-grounding.
Do not insert multiple devices in a single power socket. Otherwise, it may cause a power
overload.
For a stable power supply, this product provides two separate separate adaptors and two
corresponding AC cords by factory default. Make sure all cables are connected properly.
Power Connection
Connecting to a
monitor