Concept Pro VXH960-16 User Manual - page 32
29
Motion Area Setup
From the motion setup window, click
display the area setup screen.
Setting the motion area may diff er depending on the camera model. Below is
a typical setting of the motion area.
1.
Click
2.
If using the remote control, press the [ENTER] button to mark the
current position.
3.
Use the arrow buttons to move to a desired block and press [ENTER].
The area setup will begin.
Then, use the arrow buttons to specify the area.
R
Alternatively, you can use the drag-and-drop method to specify or
release the area when using the mouse.
4.
If you select the specifi ed area again, it will be released.
5.
Press the [EXIT] button on the remote control or right-click any area to
display the popup window as shown in the picture to the left.
6.
While the popup window is displayed, select
motion detection sensitivity of the channel currently selected.
>
Channel: Select the channel to set the motion sensitivity.
>
SENSITIVITY: 1 (Low) ~ 30 (High) - The higher
the number is, the higher the sensitivity level becomes.
>
DAYTIME: specify the time period that will be considered as
daytime.
-
DAYTIME: specify the
-
NIGHTTIME: specify the
R
Images recorded in a low contrast scene such as at night cause severe
noise, triggering the motion event too often.
R
If unwanted events occur frequently at night, you may want to reduce
the motion sensitivity during the night .
Camera Setting
System
Settings