Concept Pro VXH960-16 User Manual - page 50
47
Disk Information
Show information about the connected HDDs.
1.
From
2.
Use the [pqtu/ENTER] buttons on the remote control or use
the mouse to select either STORAGE>. Please check the status for each connected device. > START / END TIME: show the start time and end time of data stored in each HDD. > STATUS: Check if the connected HDD is being used by the VXH960. If you encounter a problem with the HDD, the VXH960 will terminate the connection to the HDD and mark it as ‘Not In Use’. > CAPACITY: Show the capacity of the HDD. > MODEL: Indicate the HDD model number > S.M.A.R.T STATUS: Read the S.M.A.R.T information of the HDD and check to display if the current HDD is in normal operation. - NORMAL: The HDD is in a normal state. - CHECK: The HDD has an error, contact your service provider. It is recommended that you replace the HDD immediately If you leave the problem unresolved, it may stop recording - ERROR: The HDD fails or is unable to be used due to an error of the HDD or the cable. The HDD should be replaced immediately. Contact your service provider immediately. 3. When done, press the [EXIT] button on the remote control or click You can confi gure the settings and view the information of the disk and external storage devices. System Settings Storage System Settings