Connex ProSight Installation And Operation Manual - page 12
Manual is about: HD FPV Vision Kit (Transmitter, Receiver, Camera) for Drone
of
78
12
Installing the Units|Connecting Components to Drone
Doc P/N: 9040962 | Rev 04 | Printed 03 January 2017
Navigation pane
Connecting Components to Drone
Preparing the Mounting Plate
Mark mounting holes for the following components:
•
Camera (1) – 3 holes
•
Transmitter (3) – 4 holes
•
Antenna (4) – 4 holes
1
2
3
4
Notes:
• Consider the
length (2 3/4inch / 7cm) between the camera and the transmitter (2).
• The HD transmitter heats up quickly. For optimum functionality, install the HD transmitter in a well ventilated location
on the drone.
CONNEX ProSight Installation and Operation Guide