Connex ProSight Installation And Operation Manual - page 68
68
Configuration Using ProSight Mobile Application |Main Menu Options
Doc P/N: 9040962 | Rev 04 | Printed 03 January 2017
Navigation pane
Frequency Management
To set the frequency mode, tap one of the following modes:
•
Auto (1) – constantly searches for the optimal frequency.
•
Fixed –
»
ProSight Bands (2) – enables selecting a race set. Each set
consists of two frequencies within the DFS spectrum. The system
scans to verify that there is no interference with other devices
and will switch between the two frequencies when required.
»
Fixed frequency (3) – lists fixed frequencies for manual
selection. Once a certain frequency is selected, the HD
transmitter uses only the selected frequency.
For more information on Frequency Management, see
1
2
3
Tip:
Frequency management is available only when the HD receiver is
connected to its paired HD transmitter.
CONNEX ProSight Installation and Operation Guide