Connex ProSight Installation And Operation Manual - page 52
52
Operating the Units|Setup Menu Options
Doc P/N: 9040962 | Rev 04 | Printed 03 January 2017
Navigation pane
Detailed Overlay
The Detailed overlay displays the following information on top of the live
video:
•
Transmitter name (1)
•
Frequency mode (3)
•
Signal level (2) – there are three levels:
»
– best signal
»
– signal is weakening
»
– it is recommended to bring the drone closer to the receiver
•
Battery voltage (4) – blinks and turns red if the measured voltage is below the predefined threshold (see
•
Flight duration (5) – counts the flight time in seconds. Count start time depends on the following:
»
When the HD transmitter telemetry port is connected to the flight controller, time starts counting when the drone is armed.
»
When the telemetry port is not connected, time starts counting once the drone is powered on.
1
5
2
4
3
CONNEX ProSight Installation and Operation Guide