Connex ProSight Installation And Operation Manual - page 28
Manual is about: HD FPV Vision Kit (Transmitter, Receiver, Camera) for Drone
of
78
28
Installing the Units|Wiring the HD Receiver
Doc P/N: 9040962 | Rev 04 | Printed 03 January 2017
Navigation pane
B-
Connecting to Power
To connect the HD receiver to a power source:
1. Connect the
to the HD receiver power
port (1) and the other end to a power source.
2. Verify that the Network LED (2) on the HD receiver blinks for a few
seconds and then stays lit.
1
2
Tips:
• The HD receiver can be connected directly to the battery.
• The HD receiver is compatible with 7V to 17V, or 2S to 4S
batteries.
CONNEX ProSight Installation and Operation Guide