Connex ProSight Installation And Operation Manual - page 21
21
Installing the Units|Wiring the HD Transmitter
Doc P/N: 9040962 | Rev 04 | Printed 03 January 2017
Navigation pane
Configuring a Flight Controller that Runs CleanFlight
The flight controller has a specific UART port that supports MAVLink. To receive telemetry information from the flight controller, the MAVLink port
needs to be configured through CleanFlight as follows:
1. Connect MAVLink to the appropriate UART (MAVLink output port) of the flight controller .
2. Burn the CleanFlight (version 1.13 and above).
3. Open the CleanFlight configurator and connect to
Flight Controller.
4. Under
Other Features, enable TELEMETRY.
5. Press
Save and Reboot.
6. Go to
CLI.
7. Write
serial to see all available serial ports. Ports 0,1 and 2 are HW UART.
8. Write the following line:
serial 1 256 115200 57600 57600 115200.
•
1 – is the HW UART port
•
256 – will cause the FC to use MAVLink on port 31
•
57600 – is the UART’s baudrate
9. Type
save to save and reboot.
Note:
The flight controller must support MAVLink.
CONNEX ProSight Installation and Operation Guide