D-Link DGS-3204 - Switch - EN 100VG-AnyLAN User Manual - page 62
Gigabit Ethernet Switch User’s Guide
48
Using the Console Interface
Configure Ports
The port configuration screen allows you to change the port
state in the case when you would like to partition a port, or
for observation, device repair, or security reasons. Great
caution, however, must be observed when partitioning a
port; you should make sure that the partitioned port is not
being used as the port to control or monitor the condition of
other devices.
To change the configuration of a port:
1.
Select System Configuration from the main menu and
then choose Configure Ports. The following screen
appears:
Figure 6-12. Port Configuration screen
2.
Specify the port in the Port (1-4) field.
3.
In the State field, change the port state to Enabled or
Disabled.