D-Link DGS-3204 - Switch - EN 100VG-AnyLAN User Manual - page 66
Manual is about: User Guide
of
140
Gigabit Ethernet Switch User’s Guide
52
Using the Console Interface
explained in Chapter 5’s Switch Management, see STA
Operation Levels: On the Bridge level, and User-Changeable
Parameters. It is recommended that you read these sections,
as well as the introductory section in the same chapter
entitled Spanning Tree Algorithm before changing any of
the parameters.
To change the Protocol Parameters:
1.
Choose Configure Spanning Tree Protocol from the
System Configuration menu. The following Spanning
Tree Protocol Configuration menu will be displayed:
Figure 6-14. Spanning Tree Protocol Configuration menu
2.
Choose STP Parameters Setting to access the
following screen: