D-Link DGS-3204 - Switch - EN 100VG-AnyLAN User Manual - page 99
Manual is about: User Guide
of
140
Gigabit Ethernet Switch User’s Guide
Web-Based Network Management
85
Ports Setup
Select the port you want to configure by clicking on
the port in the Switch front panel display at the top of
the screen or by using the screen displayed above.
Follow these steps:
1.
Enable or disable the port. If you choose Disabled,
devices connected to that port cannot use the
Switch, and the Switch purges their addresses from
its address table after the MAC address aging time
elapses. The Switch won't purge addresses if you
define them as permanent entries in the
Forwarding Table.
2.
Configure the Speed/Duplex setting for the port.
The only option is 1000M/Full, which means port
operation at 1000 Mbps in full duplex mode.