D-Link DGS-3204 - Switch - EN 100VG-AnyLAN User Manual - page 97
Manual is about: User Guide
of
140
Gigabit Ethernet Switch User’s Guide
Web-Based Network Management
83
TCP/IP Setup
You can change the IP Address, Subnet Mask, and Default
Gateway on the Switch. If you are not using BOOTP, enter
the IP Address, Subnet Mask, and Default Gateway of the
Switch. If you enable BOOTP, you do not need to configure
any IP parameters because a BOOTP server automatically
assigns IP configuration parameters to the Switch. Click
Apply to activate the new settings.
The information is described as follows:
♦
IP Address The Internet address for the device.
♦
Subnet Mask The subnet mask determines the
level of the subnet that the Switch is on.
♦
Default Gateway The default router for the
device.