EcoQuest Fresh Air Owner's Manual - page 15
4. The UV lamp is not functioning / I’m getting a “Replace Lamp” message.
• Check lamp for proper installation.
• Replace UV Lamp.
PLEASE NOTE: If unit has been recently transported check lamp
for proper installation, remove Lamp and reinstall.
5. What are the most typical application problems?
• Symptom: A belief that the proper equipment is placed in the
environment and the equipment appears unsuccessful.
Problem: Lack of air movement, improper placement of the unit.
• Symptom: Strong odors still remain within the environment after
placement.
Problem: Purifier setting is too low or improper placement of the
unit.
• Symptom: A strong odor of ozone is present within the
environment.
Problem: Too much ozone accumulation within the environment
as a result of improper purifier control setting, and / or lack of air
movement.
• Symptom: Visual haze of smoke and / or particulate remain
within the environment.
Problem: Lack of ionization and / or air movement.
6. How can I tell if the UV lamp is functioning?
• The UV lamp will produce a glow that is visible through the front
grill under low light conditions
CAUTION: Do not look directly at the glowing lamp.
7. Unit does not operate -
• Is the unit plugged in?
• Are you sure the outlet is active?
• Is the main power switch turned on?
• Is the rear lint screen installed properly to depress the safety
switch downward?
• Does the fuse need to be replaced?
8. Air flow is restricted or reduced -
• Is the unit properly placed away from objects that may obstruct
air flow?
• Are the lint screen (or EcoHelp filter) and front grill housing clean?
• Is the catalytic screen clean?
If your unit fails to operate properly after performing trouble-shooting,
contact your EcoQuest Dealer for further assistance, contact EcoQuest
at the address located on the front of the manual, or visit
www.EcoQuest.com for additional support.
15