EcoQuest Fresh Air Owner's Manual - page 3
3
1. Remove protective packaging.
2. Remove unit from shipping carton.
3. Remove all protective materials.
4. Check for shipping damage and loose or broken parts.
5. Read Owners Manual thoroughly prior to installation.
6. Install batteries in remote.
7. Determine placement location for the unit (See “Placement of
Unit” on page 9), plug the unit into a 110 volt outlet.
8. Be sure the main power switch (on back of unit - see page 5)
is in the ON position.
9. Using either the remote control or the Power button, turn the
unit ON. The display should look similar to below.
INSPECTION & INSTALLATION
OPERATION
1. Adjust the fan speed to your preference keeping in mind that
higher fan speeds will give better results.
2. Set the purifier controls anywhere from zero up to the total
area of the indoor environment.
Do not set the area indicated by the purifier above the square footage
(or square meters for international models) of the indoor area.
3. To operate the sanitize feature, press the sanitize button until
the desired time is reached (2, 4, 6, or 8 hours). The unit will
display SANITIZE and the remaining time in hours and
minutes (see below). Make sure the area is unoccupied before
using the sanitizer. To interupt the sanitize feature before the
timer reaches zero, press the Purifier On/Off button.
Sanitize Mode
Fan Speed (Max)
SANITIZE MODE: The unit’s display will change when the Sanitize function is
active. The fan will show maximum and SANITIZE will replace the purifier
setting. The amount of time remaining will depend on how long you have
selected for the Sanitize function to operate. The colon (:) will flash to indicate
time being count down.
Time Remaining
Purifier Setting
Fan Speed
Purifier Coverage
NORMAL MODE: The unit’s display shows the fan speed (low to high), the
purifier setting (1 bar to 12 bars), and the purifier coverage in square feet for
U.S. models and square meters for international units.