EcoQuest Fresh Air Owner's Manual - page 9
9
OPTIONAL ECOHELP FILTER
Changing the UV Lamp
The UV lamp should be changed when REPLACE LAMP appears
on the display. To change the lamp follow the instructions on
pages 10 - 13.
Changing the fuse:
The fuse may be accessed by
unplugging the cord from the
back of the unit and gently
pulling the fuse holder
straight out.
PLACEMENT OF UNIT
Place the unit as high as
possible to insure
complete purification.
(On top of a bookshelf,
high cabinet, etc.)
Suggested locations,
listed in the order of
preference:
1. Nearest the source of
the worst pollution.
2. Near a cold-air return
to thoroughly circulate
clean air throughout
the area.
3. In the area most
heavily used to achieve
maximum benefit.
Note:
• The rear of the unit should always have at least one inch of
open area to allow unrestricted airflow.
• Be sure the power cord is not accessible to small children to
prevent injury.
For removal of additional dust and allergens, your Fresh Air by
EcoQuest will accommodate an optional EcoHelp filter. The
EcoHelp filter replaces the standard lint screen and is completely
covered when the unit is properly assembled. See page 13 for filter
installation instructions. Contact your EcoQuest Dealer to order
an EcoHelp filter.
100 & 110 volt models - use 1.6 Amp slow blow fuse.
220/240 volt models - use 1.0 Amp slow blow fuse.