F-SECURE ANTI-VIRUS FOR MICROSOFT EXCHANGE 8.00 - Administrator's Manual - page 273
CHAPTER 13
273
Step 3. Initiator Ports
If your service uses the TCP or UDP protocol, you need to define the
initiator ports the service covers. The format for entering the ports and
port ranges is as follows:
“>port” all ports higher than port
“>=port” all ports equal and higher than port
“
“<=port” all ports equal and lower than port
“port”, only the port
“minport-maxport”, minport and maxport plus all ports between
minport and maxport. (notice that there are no spaces on either
side of the dash)
You can define comma-separated combinations of these items. For
example ports 10, 11, 12, 100, 101, 200 and over 1023 can be defined as
“10-12, 100-101, 200, >1023”.
AH
51
Authentication Header protocol
PIM
103
Protocol Independent Multicast
COMP
108
Compression Header protocol
RAW
255
Raw IP packets