Ferm FGG-2000N User Manual - page 6
Ferm
4
43
3
3
3.. U
US
SE
E
B
BE
EF
FO
OR
RE
E S
ST
TA
AR
RT
TIIN
NG
G T
TH
HE
E
G
GE
EN
NE
ER
RA
AT
TO
OR
R
Ground terminal
The generator ground terminal is
connected to the frame of the generator, the
metal non-current-carrying parts of the
generator, and the ground terminals of each
receptacle. Before using the ground terminal,
consult a qualified electrician, electrical
inspector or local agency having jurisdiction for
local codes or ordinances that apply to the
intended use of the generator.
F
Fiillll a
an
nd
d c
ch
he
ec
ck
k o
oiill lle
ev
ve
ell ((q
qu
ua
an
nttiitty
y iis
s 6
60
00
0 m
mll))
Always check the oil level (with machine in a
level position) before starting and if the
engine unexpectedly stops (fig. 2).
For general use you can use an “all
temperature” oil 10W-30
≤
0ºC
SAE#10
0ºC - 25 ºC
SAE#20
25ºC -35 ºC
SAE#30
≥
35ºC
SAE#40
F
Fiillll a
an
nd
d c
ch
he
ec
ck
k ffu
ue
ell lle
ev
ve
ell
• Use unleaded fuel only
• Remove any power cords
• Turn power switches off
• Do not overfill – leave air gap at top of fuel
level
• Always screw down fuel cap
• Clean up any spilled fuel
• Do not smoke while operating the
generator
Always use caution!
S
Stta
arrttiin
ng
g tth
he
e g
ge
en
ne
erra
atto
orr
F
Fiig
g.. 1
1 +
+ 4
4 +
+ 5
5
1. Turn on fuel tap (15).
2. Turn on engine switch (12).
3. Move choke lever (13) to closed position
(to restart a warm engine, leave the choke
lever in open or half-open position).
4. Pull slowly on the starter cord until it
engages, then pull sharply to start the
engine (14).
5. Allow the engine to run until it warms up,
and then move the choke lever to the open
position (13).
U
Us
siin
ng
g tth
he
e A
AC
C O
Ou
uttp
pu
utt ((2
23
30
0 V
V))
• Start the generator.
• Plug in the electrical appliance plug.
• Press AC current protector downward to
“ON”(7).
• The voltmeter (11) displays the voltage on
the AC socket. Normally this should be ±
230 V during use.
S
Stto
op
pp
piin
ng
g tth
he
e g
ge
en
ne
erra
atto
orr
F
Fiig
g.. 1
1 +
+ 5
5
1. Unplug all cords (5)
2. Turn engine switch to “OFF” (12)
3. Turn off fuel tap (15)
4
4.. S
SE
ER
RV
VIIC
CE
E &
& M
MA
AIIN
NT
TE
EN
NA
AN
NC
CE
E
P
PE
ER
RIIO
OD
DIIC
C M
MA
AIIN
NT
TE
EN
NA
AN
NC
CE
E
Daily (pre-operation check)
• Check engine oil level
• Check fuel hose for cracks or other
damage. Replace if necessary.
• Check exhaust-system for leakage.
Retighten or replace gasket if necessary.
• Check choke operation
• Check recoil starter operation
1
1s
stt M
Mo
on
ntth
h o
orr 2
20
0 h
hrrs
s
• Replace engine oil
3
3 M
Mo
on
ntth
hs
s o
orr 5
50
0 h
hrrs
s
• Check condition of spark plug. Adjust gap
and clean. Replace if necessary.
• Clean, replace if necessary.
6
6 M
Mo
on
ntth
hs
s o
orr 1
10
00
0 h
hrrs
s
• Replace engine oil
• Clean fuel tap and fuel tank filter. Replace if
necessary.
• Check fittings and fasteners. Replace if
necessary.
1
12
2 M
Mo
on
ntth
hs
s o
orr 3
30
00
0 h
hrrs
s
• Contact a specialized service centre to
check the valve clearance.
• Check the fan of the cooling system for
damage.
6
6
Ferm