Garland XE24 Installation, Operating & Service Instructions - Operation Continued
Part # 4517125 (09/03)
Page 13
PLATEN SET:
This function allows the platen to be moved up or down
once it is parallel to the grill surface. Values range from
–160 to +160.
EXTENDED TIME:
This option will add 6, 4 and 2 seconds to the time of
the next three cooks respectively if the grill has had no
activity for 5 minutes. Provided the temperature is not
25°F above set temperature for either the grill or the
platen.
OPERATION continued
INSTANT ON TIME:
This can be set in the range of 00:00 to 00:40. Instant
on will turn on the heat zone(s) as soon as a cook cycle
starts.
START DELAY:
This number is how long the operator must hold the
GREEN (‘CANCEL/RAISE’) and BLACK buttons
to start a cooking cycle for 2-sided recipes only. There
will be one beep when the cook is started and another
beep when the START DELAY time is reached. If the
GREEN (‘CANCEL/RAISE’) and BLACK buttons are
released before that time the cook will be canceled. If Yes
is toggled press enter to allow the user to pick from 1 to
5 seconds in 0.5 second increments using and .
CLEANING AND MAINTENANCE
Cleaning During Operation:
1. After each product load is removed, Use a grill
scraper to scrape grease on lower grill plate from
front to back only. Do not scrape left to right across
the lower grill plate with the grill scraper.
2. Use a grill squeegee to clean release material sheet
on upper platen in a downward motion. Do not
press hard against the release material sheet to
prevent scratching or tearing.
3. Push the grease to the rear of the grill, or pull it to
the front trough. Then, squeegee the grease into the
buckets on either side. Do not use the scraper for
this step.
4. Use a clean, damp cloth to clean back splash and
bullnose areas as needed during operation.
Note: To increase life of release material sheets, wipe
them down with a folded clean, damp cloth at least
four times during each hour of operation.
Daily Cleaning:
Warning: The upper platen surface and edges are very
hot! To prevent burn injuries, use extreme caution when
wiping down release sheets and platen edges.
1. Press the or button to obtain the menu item
“CLEAN MODE.”
2. Press to acknowledge that Clean Mode is desired.
This will cause the appliance (grill and platen, if
selected) to heat to the Clean Temperature.
3. “READY TO CLEAN” will be displayed when the
grill is at the proper cleaning temperature and an
audible alarm will sound.
4. To exit Cleaning Mode, press . The Display will
show “OFF.””
5. Wearing protective gloves, empty and replace the
grease troughs.
6. Wipe down the exposed surface of the release sheet
with a clean, damp cloth.