Garland XE24 Installation, Operating & Service Instructions - Programming Continued
Part # 4517125 (09/03)
Page 24
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” will be displayed.
5. Press eleven, (11) times. “START DELAY YES
(or NO)” will be displayed.
6. Use and to turn Start Delay on or off.
7. If Start Delay is On (YES), press
to display
“DELAY TIME XX:XX”
8. Use and to set the Delay Time to the desired
value.
9. Press to save the changes.
10. Press to return to “PROGRAMMING MODE
MENU ITEMS”
11. Press again to exit.
To Change the Alarm Mode:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” will be displayed.
5. Press
twelve, (12) times. “ALARM MODE
AUTO (or MANUAL)” will be displayed.
6. Use
and
to change the Alarm Mode to
either Auto or Manual.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
MENU ITEMS”
9. Press again to exit.
PROGRAMMING continued
To Turn Clean Mode On/Off:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” will be displayed.
5. Press
thirteen, (13) times. “CLEAN MODE
YES (or NO)” will be displayed.
6. Use and to turn Clean Mode On or Off.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
MENU ITEMS”
9. Press again to exit.
Service Mode
To Change SCK Address:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
three, (3) times. “PROGRAMMING
MODE SERVICE MODE” is displayed.
5. Press
one, (1), time. “Address XX” will be
displayed.
6. Use
and
to change to the desired SCK
Address.
7. Press to save the changes.