Garland XE24 Installation, Operating & Service Instructions - Programming Continued
Part # 4517125 (09/03)
Page 21
PROGRAMMING continued
System Setup
To Change temperature Units, (°F or °C):
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” is displayed.
5. Press to enter system setup. “TEMP DISPLAY
FAHRENHEIT (or CELSIUS)” will be displayed.
6. Press to change the temperature units to either
Fahrenheit or Celsius.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
SYSTEM SETUP”
9. Press again to exit.
To Change Gap Setting Display Units:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” is displayed.
5. Press
two, (2), times. “GAP SETTING
DISPLAY INCHES (or MILLIMETERS)” will be
displayed.
6. Press
to change the Gap Setting Display units
to either Inches or Millimeters.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
SYSTEM SETUP”
9. Press again to exit.
To Change the Alarm Volume:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” is displayed.
5. Press
three, (3), times. “ALARM VOLUME
LOW (or HIGH)” will be displayed.
6. Use
or
to change the Alarm Volume to
either Low or High.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE
SYSTEM SETUP”
9. Press again to exit.
To Change Probe Calibration - Upper:
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times. “PROGRAMMING
MODE SYSTEM SETUP” is displayed.
5. Press four, (4), times. “PROBE CAL – UPPER
XXXF” will be displayed.