Garmin GMX 200 Installation Manual - page 15
GMX 200 Installation Manual
Page 2-1
190-00607-04
Revision F
2
1B
Installation Overview
2.1
16B
Introduction
This section provides an overview of what is required for a successful GMX 200 installation. Available
GMX 200 configurations are described, and installation considerations are presented.
2.2
17B
Pre-Installation Information
Always follow good avionics installation practices per FAA Advisory Circulars (AC) 43.13-1B and
43.13-2A, or later FAA approved revisions of these documents.
Follow the procedure in this manual as it is presented for a successful installation. Read the entire manual
before beginning the procedure. The GMX 200 must be mounted in an FAA approved 6.25” wide radio
stack. Perform the post installation checkout before closing the work area in case problems occur.
Complete an electrical load analysis in accordance with AC 43.13-1B, Chapter 11, on the aircraft prior to
starting modification to ensure aircraft has the ability to carry the GMX 200 load. Refer to Section
X
3.6
X
for
the power consumption information. Document the results of the electrical load analysis on FAA Form
337.
2.3
18B
Installation Materials
2.3.1
46B
Configurations Available
The GMX 200 is available in eight configurations under the following part numbers. Catalog part
numbers are shown with and without the installation kit.
Table 2-1. Configurations Available
Model
Bezel
Color
Unit P/N
Catalog P/N
Without Installation
Kit
Catalog P/N
With Installation
Kit
GMX 200
Black
011-01271-00
010-00483-00
010-00483-01
GMX 200
Gray
011-01271-10
010-00483-10
010-00483-11
GMX 200 I/O Traffic
Black
011-01465-00
010-00571-00
010-00571-01
GMX 200 I/O Traffic
Gray
011-01465-10
010-00571-10
010-00571-11
GMX 200 I/O Radar/TAWS
Black
011-01466-00
010-00486-00
010-00486-01
GMX 200 I/O Radar/TAWS
Gray
011-01466-10
010-00486-10
010-00486-11
GMX 200 I/O Traffic/Radar
Black
011-01467-00
010-00487-00
010-00487-01
GMX 200 I/O Traffic/Radar
Gray
011-01467-10
010-00487-10
010-00487-11
2.3.2
47B
Equipment Available
Each of the following accessories is provided separately for the GMX 200:
Table 2-2. Accessories Provided Separately
Item Garmin
P/N
Sub Assembly, Connector Kit, GMX 200
011-01283-00
Sub Assembly, Connector Kit, GMX 200 I/O
011-01283-01 [1]
SMP, Mounting Tube
115-00746-00
Configuration Module Sub Assembly
011-00979-02
[1] Required for GMX 200 I/O models.
Table 2-3. Options Available
Item Garmin
P/N
ChartView Kit, GMX 200
010-00489-50
WSI Activation Kit
010-00489-54