Garmin GMX 200 Installation Manual - page 44

5.3.3 

69B

Miscellaneous Setup Options 

This menu allows the installer to set up various options on the GMX 200.  Modifications can be made 

using the line select key beside the appropriate function to cycle through available selections.  Record all 

of the settings in the checkout log sheet provided in 

X

Table 5-3

X

. 

1.

  If not already on the Misc Setup Options menu, press the MISC smart key to bring up the Misc 

Setup Options menu.  Configure the options as required to match the installation. 

a.

  Ownship Broadcast Flight ID (only required if UAT/ADS-B system is installed): 

Selections: Up to eight alpha-numeric characters 

Press the line select key for this option to allow editing of the Flight ID.  Use the smart keys to 

enter/edit up to 8 characters, and press the MENU/ENTER key when done. 

b.

  Ownship Symbol:  

Selections: Single Engine, Twin Engine, Jet, Helicopter 

Select the type of ownship symbol to be displayed on the map pages.  

c.

  Terrain Clearance Mode:  

Selections: Normal, Special 

Set to Normal for all operations.  

d.

  Demo Mode (Not for Flight):  

Selections: Disabled, Enabled 

Select Disabled for all aircraft installations.  Selecting Enabled causes the GMX 200 to 

operate in demo mode and simulate many of its inputs. 

e.

  Radar Indicator:  

Selections: All, 1, 2 

Select the Radar Indicator number that the GMX 200 will be in the installation. This number 

should match the indicator number for the channel of the radar to which the GMX 200’s 

ARINC 429 control lines are connected.  The ALL option must be selected when the GMX 

200 is connected to a GWX 68.  The ALL option is not recommended when there are multiple 

radar control/display devices being used.  

Page 5-10 

GMX 200 Installation Manual 

Revision F 

190-00607-04