Installation instruc- tions easycoder f4 cutter.
Information in this manual is subject to change without prior notice and does not represent a commitment on the part of intermec printer ab. © copyright intermec printer ab 2002. All rights reserved. Published in sweden. Easycoder, easylan, fingerprint, and labelshop are registered trademarks of int...
Intermec easycoder f4 cutter – installation instructions ed. 3 1 chapter 1 description the cutter is a factory-installed or fi eld-installable option for the easycoder f4-series printers. The cutter automatically cuts off the media after printing according to instructions in the controlling fi rmwar...
Intermec easycoder f4 cutter – installation instructions ed. 3 2 chapter 2 the easycoder f4 cutter is easy to install and requires no modifi cation of the printer itself. The installation kit contains: - cutter unit (1) - tray (1) - cable (1) - cable cover (1) - #t20 torx screws and washers (3) - in...
Intermec easycoder f4 cutter – installation instructions ed. 3 3 chapter 2 installation bracket fi ts into the corresponding holes in the printer’s bottom plate. Fit it using the three #t20 torx screws and washers included in the kit. • route the cutter cable through the slot in the bottom plate as ...
Intermec easycoder f4 cutter – installation instructions ed. 3 4 chapter 3 operation the cutter is activated by cut or cut on statements, see the intermec fingerprint v7.Xx, reference manual or the intermec direct protocol v7.Xx, programmer's guide. Application programs may have related facilities f...
Intermec printer ab idrottsvägen 10, p.O. Box 123 s-431 22 mölndal, sweden tel +46 31 869500 fax +46 31 869595 www.Intermec.Com *1-960492-02* easycoder f4 cutter — installation instructions *1-960492-02*.
