Intermec EasyCoder F4 Reference Manual

Manual is about: Intermec EasyCoder 501XP: Reference Guide

Page of 6

Download

Bookmark us

Intermec EasyCoder F4

EasySet Bar Code Wand Setup

1. Connect the EasySet bar code wand to the

receptacle on the printer’s rear plate.

2. Read the appropriate bar code to set up the prin-

ter. Hold the wand like a pencil and move it

rather swiftly across the bar code.

3. When the bar code has been accepted, the prin-

ter emits a short beep and the Ready control

lamp on the printer’s front blinks briefly.

4. This sheet only contains a selection of setup

options. For information on how to produce your

own setup bar codes, please refer to the Inter-

mec Fingerprint 7.2 Reference Manual.

Serial Communication on ”uart1:”

Baudrate

1-960480-00 EasySet Bar Code Sheet for EasyCoder F4 Edition 1, October 1999

Connect here!

1 2 3 4 5 6 Next › »

Page 1
1 intermec easycoder f4 easyset bar code wand setup 1. Connect the easyset bar code wand to the receptacle on the printer’s rear plate. 2. Read the appropriate bar code to set up the prin- ter. Hold the wand like a pencil and move it rather swiftly across the bar code. 3. When the bar code has been ...
Page 2
2 serial communication on ”uart1:”, cont’d. No. Of stop bits rts/cts enq/ack xon/xoff, data to host reset comm. To default parity char. Length.
Page 3: Start- and Stopadjust
3 peel off start- and stopadjust tear off media contrast xon/xoff, data from host new line serial communication on ”uart1:”, cont’d. Default.
Page 4: Media, Cont’D.
4 media, cont’d. Media width media length.
Page 5: Media, Cont’D.
5 media, cont’d. Print speed test labels media type.
Page 6: Paper Type
6 direct thermal printing (europe) paper type direct thermal printing (usa).