Jcb JCB-SCMS210 Safety And Operating Manual - Operation

3

OPERATION 

1. THE HOLD DOWN CLAMP 

(See     )

Two sockets (one either side) are 

incorporated into the rear of the 

machines fence. These sockets are 

for positioning the Hold Down Clamp.

1)  Fit the clamp to the retaining 

socket that best suits the cutting 

application, ensuring that it is fully 

pushed down.

2) Tighten the fence thumbscrew to 

lock the pillar of the clamp into the 

fence socket. 

3) Place the workpiece to be cut 

onto the saw table, against the 

fence and in the desired position.

4) Adjust the clamp using the 

thumbscrews and hand-wheel 

so that it securely holds the 

workpiece to the saw table. 

Conduct a ‘dry run’ with the power 

disconnected.  Ensure that the Hold 

Down Clamp does not interfere with 

the path of the blade, or with the path 

of any other part of the Cutting Head 

as it is lowered.

3