Jcb JCB-SCMS210 Safety And Operating Manual - Clearing Jammed Material

CLEARING JAMMED MATERIAL

1) Turn mitre saw “OFF” by releasing 

the trigger switch.

2) Allow the blade to come to a 

complete halt.

3) Unplug the mitre saw from the 

mains supply.

4) Carefully remove any jammed 

material from the machine.

5) Check the condition and operation 

of the safety guard.

6) Check for any other damage to any 

part of the machine e.g. the blade.

7) Have any damaged parts replaced 

by a competent technician and a 

safety inspection carried out before 

using the machine again.

CUTTING CROWN MOULDING 

Your JCB Sliding Mitre Saw is 

suited to the difficult task of cutting 

crown moulding. To fit properly, 

crown moulding must be compound 

mitred with extreme accuracy. The 

two surfaces on a piece of crown 

moulding that fit flat against the 

ceiling and wall are at angles that, 

when added together, equal exactly 

90°.

33.9

0

   CROWN MOULDING BEVEL 

STOP

A positive stop set at 33.9

0

 to the Left 

Hand is available when the Crown 

Moulding Pin is deployed. (See      )

28