Jcb JCB-SCMS210 Safety And Operating Manual - page 5

its intended function. Check for 

misalignment or binding of moving 

parts, breakage of parts, and any 

other condition that may affect the 

tool’s operation. A guard or other part 

that is damaged should be properly 

repaired or replaced at a qualified 

service centre. Keep guards in place 

and in working order.

7. Do not abuse the cord. Never 

use the cord to carry the tool or pull 

the plug from the outlet. Keep cord 

away from heat, oil, sharp edges or 

moving parts. Replace damaged 

cords immediately. Damaged cords 

increase the risk of electric shock. 

8. Always make sure that your 

extension cord is in good condition. 

When using an extension cord be 

sure to use one that is heavy enough 

to carry the current that your tool will 

draw. An undersized cord will cause 

a drop in line voltage, resulting in loss 

of power and overheating.

9. Do not use the tool while 

tired or under the influence of 

drugs, alcohol or any medication. 

Following this instruction will reduce 

the risk of electric shock, fire or 

serious personal injury. 

10. Save these instructions. Refer 

to them frequently and use them to 

instruct others who may use this tool. 

If someone borrows this tool, make 

sure they have these instructions 

also. 

11. Do not use saw blades with 

High Speed Steel (HSS) or blades 

that are damaged or deformed. 

12. Replace the table insert when 

worn. 

13. Use only saw blades 

recommended by the manufacturer 

and which are the exact bore and 

diameter required for this machine 

and conform to EN 847-1   

14. Connect your mitre saw to a dust 

collecting device (I.D.Ø32mm) when 

sawing material likely to cause dust. 

15. Select saw blades in relation 

to the material to be cut. Use 

only genuine JCB recommended 

accessories.

16. Check the maximum depth of cut. 

17. When sawing long work 

pieces, always use extra support 

to provide better support, and use 

clamps or other clamping devices. 

To reduce the risk of injury, return the 

slide carriage to the full rear position 

after each crosscut operation.

18. Ensure that the operator is 

adequately trained in the use 

adjustment and operation and 

operation of the machine. 

19. Provide for adequate room 

lighting at your workplace or for 

adequate lighting of the immediate 

work area.  

20. When fitted with a laser no 

exchange with a different type 

of laser is permissible. Repairs