Jcb JCB-SCMS210 Safety And Operating Manual - Checking and Setting of

CHECKING AND SETTING OF 

PRECISION ANGLES

 WARNING: Only attempt  

these procedures with the 

machine disconnected from the 

power supply.

NOTE: When checking angular 

alignments the Cutting Head should 

be lowered and locked in the down 

position with the latching pin fully 

located in its socket.

0

0

 Bevel Stop Adjustment

1. Ensure that the Cutting Head is 

upright against its stop and the Bevel 

Pointer is indicating ‘0

0

’ on the scale.

(See      )

2. Place a combination square (not 

supplied) on the mitre table with one 

edge against the table and the other 

edge against the blade. (See      )

3. If the blade is not 90

0

 square with 

the mitre table adjustment is required.

4. Loosen the Bevel Lock Handle and 

tilt the Cutting Head to the left.

5. Loosen the locknut on the Bevel 

Angle Adjustment Screw. (See      )

6. Use an Hex Key to adjust 

the screw in or out to adjust the 

inclination of the blade.

7. Return the Cutting Head to its 

upright position and recheck angular 

alignment against the combination 

square.

30

31

29