Jcb JCB-SCMS210 Safety And Operating Manual - Basic Slide Cutting

8) Allow the speed of the blade to 

do the work, there is no need to 

apply undue pressure to the Cutting 

Handle.

9) When the cut has been completed, 

release the ON/OFF trigger switch.

10) Allow the blade to come to a 

complete stop.

11) Allow the Cutting Head to rise 

to its upper position, with the lower 

blade guard completely covering the 

blade teeth, and the Cutting Head 

locked in the upper position, before 

releasing the Cutting Handle.

12) Remove the workpiece 

BASIC SLIDE CUTTING

This saw is equipped with a Sliding 

Carriage system.

Loosening the slide lock screw 

will release the slide and allow the 

Cutting Head to move forwards and 

backwards. (See      )

The saw blade is lowered into the 

workpiece and then pushed to the 

rear of the machine to complete a 

cut. This type of cut can be used for 

cutting wide pieces.

1) Position the workpiece on the table 

and against the fence and secure 

with clamp(s) as appropriate.

2) Loosen the slide lock screw.

3)  Grasp the Cutting Handle and pull 

the Cutting Head forward until the 

arbor (centre of saw blade) is over the 

front edge of the workpiece. (See      )

4) Operate the ON/OFF motor trigger 

20

21