K-Circle Base Module Instruction Manual - Base Module - Functions

10

BASE MODULE - FUNCTIONS

FRONT BUTTONS

(0) AF•EXIT  

autofocus • exit

PRESS: exit from the current function, if inside Digital Zoom Position change axis.

HOLD: perform AutoFocus / Metering while holding button. Release to stop.

(1) LV•DZ•DZP             

liveview • digital zoom • digital zoom 

position

PRESS: digital zoom - on every press cycle thru 5x,10x,1x (normal)

HOLD: go in LiveView, hold again to deactivate. If you are not in LiveView, an 

unique press activate it. The camera focusing moves only in LiveView, and also 

all movie recording features (Canon specific features).

LONG HOLD: zoom area movement, rotating the knob you can move on the X 

axis. Push EXIT button to switch to Y axis movement, rotate the knob to go to 

position. Pushing once EXIT cycles you thru X and Y axis. Once you found the 

correct position, just press the button again to exit the function.

(2) ISO•EXP  

iso • exposure compensation

PRESS: iso change, rotate knob to change values, press again to exit

HOLD: exposure change, rotate knob to change values, press to exit

1

2

3

4

6

7

8

9

10

0

5

11