K-Circle Base Module Instruction Manual - Knob Reverse
6
KNOB REVERSE
INPUT DIAGNOSTICS
To reverse the action of the knob, while nothing is attached to the unit and it’s
powered on, hold button 1 for 5s, then power cycle the unit.
To enter input diagnostics, while nothing is attached to the unit and it’s
powered on, hold button 5 for 5s. The led will turn off, and for each button you
press it will turn on, indicating the button is working. Rotating the knob will
result in two different colors. To exit from the procedure, switch off the unit.
SPECIAL FUNCTIONS - BASE MODULE
PHOTO/VIDEO PRIORITY
This function set which action to do when the REC (button 6) is pressed. If in
PHOTO priority it captures a photo, if in VIDEO priority, start a video.
To activate it, while connected to the DSLR, hold button 6 for 2 orange blinks.
To return to the previous setting, repeat the operation.
WIRELESS ID CHANGE
This function set which ID is used for wireless communications. The BASE and
REMOTE modules must be on the same channel to work correctly. To change
the channel, while the unit is turned on and not connected to a camera, hold
button 4 for over than three seconds, then release. The unit will blink red.
There are three IDs available, the first one make a red blink on the led, the
second makes two blinks, the third three red blinks. Repeat the operation till
you get the number of ID you need.
ENABLE/DISABLE WIRELESS RADIO
This function is used to disable the radio wireless system when using only the
BASE MODULE. To disable, while the unit is turned on and not connected to a
camera, hold button 3 for over than three seconds, then release. The unit will
blink red (radio off) or green (radio on).
To prevent excessive battery consumption, if not using wireless, turn it off with
the above procedure.