K-Circle Base Module Instruction Manual - Status Led - Remote Module

19

STATUS LED - REMOTE MODULE

Once the remote module is turned on, the software automatically check for a 

valid Base Module on the same Radio ID, if one is found the main led start to 

reflect the same state of the Base Module. If no wireless base module is found, 

the unit blink red.

status led

WIRELESS CONNECTING TO BASE MODULE

When base module is in range, the Remote Module’s red led stops blinking and 

become of the same color combination of the base module. If the signal is lost, 

the base unit keeps operating while the remote needs to get in range again, 

and automatically link again to the base.

no wireless base module 

found

steady when normal 

operation

steady while movie 

recording

short blink every 5 sec.: 

recharge battery

short green/off blink while 

pulling focus or pressing BWD, 

FWD

short

short

short

long

3 fast red blinks and 1 slow 

green blink: no camera 

detected