K-Circle Base Module Instruction Manual - page 14

14

Controller does not operate

• Make sure the unit is powered correctly, if red led is blinking recharge the unit

• Make sure it is turned on correctly

Controller does not switch to green steady led when connected

• Make sure the camera attached si compatible

• Control cables

• Control that the camera did not enter auto standby/poweroff mode

• If the camera was for some reason locked, do the procedure of unplug 

battery and replug it almost 5 seconds later.

Camera become not responsive

• Turn off the camera, remove battery, wait 5 seconds - turn on again.

If the green led is not steady, power cycle also the K-Circle unit.

Focus points are not accurate

• Make sure the CPS (commands per second) do not exceed 11 or lower. 

Changing CPS, step size and focus position affects the saved point. Redo the 

focus point setup each time you change CPS or step size.

• Some lenses suffer from mechanical problem called backlash that result in a 

focus shift. Usually are cheap lenses.

TROUBLESHOOTING - BASE MODULE