K-Circle Base Module Instruction Manual - Functions
20
FUNCTIONS
Refer to the base unit’s function descriptions. All functions are replicated
from the base module. If the wireless module loose the link while changing a
function, 5 seconds later it exits and return to normal operation when in range
again.
SPECIAL FUNCTIONS - REMOTE MODULE
WIRELESS ID CHANGE
This function set which ID is used for wireless communications. The BASE and
REMOTE modules must be on the same channel to work correctly. To change
the channel, while the unit is turned on and not connected to a camera, hold
button 4 for over than three seconds, then release. The unit will blink red.
There are three IDs available, the first one make a red blink on the led, the
second makes two blinks, the third three red blinks. Repeat the operation till
you get the number of ID you need.
REMOTE HOLD
This function is used to disable all function on the base unit, and operate only
from the remote unit. All buttons and the know will be disabled.
To activate it, while the unit is turned on and associate to a base module, hold
button 7 for over than three secons. The led will blink alternate red/orange and
the hold function will be activated. Repeat the operation (or power cycle both
the base and the remote modules) to turn off the remote hold.