K-Circle Base Module Instruction Manual - Compatibility
8
COMPATIBILITY
OPERATIONS
List of compatible DLSRs (at present Canon brand only) :
• EOS 1D Mark IV
• EOS 1DX
• EOS 5D Mark II
• EOS 5D Mark III
• EOS 6D
• EOS 7D
• EOS 60D
• EOS 500D/Rebel T1/Kiss X3
• EOS 550D/Rebel T2/Kiss X4
• EOS 600D/Rebel T3/Kiss X5
• EOS 650D/Rebel T4/Kiss X6
There are 11 function buttons available, every button have more than a
function. Each function is marked near the button.
To enter the first function, press once the button, to enter the second function
hold the button till the led blinks red once, then release.
To enter in the third function hold the button till the led blinks red two times
(at least two sec.).
When entered a function, to increase or decrease values turn the knob
clockwise or counterclockwise. It’s also possible to use FWD and BWD buttons
to increase/decrease values. If nothing is changed on the unit, 5 seconds later
the controller exit automatically from the function.
NOTE: in some models the MOD button switch may not operate, due to some
Canon’s firmware limitations. You have to operate the mode selection by the
camera’s selector knob.
NOTE: The motor assisted focusing, turning the knob, works ONLY in LiveView.
This is a limit of the Canon internal software.